Chase Sapphire Commercial Skiing

Renovation - Basement - Roof - moisture

Typical seal cases for old buildings:

Wet basement, damp walls, mold, are all known consequences of missing or leaking seal. Clear that the seal here lasting solutions to hand.

But just in old buildings, the building by non-functioning seals are endangered in several parts of the building from basement to roof. In the following examples we will show you typical cases in which seal you can count on us:
on the seal.


External basement waterproofing:

wet basement can not be used and put the buildings. To the basement with a new, permanent safe seal to be reused, we offer three methods: from the outside by means of a polymer-modified thick coating or
cold self-adhesive waterproofing membrane while the entire exterior wall surface coated and thus protected from water entry. An alternative is the so-called veil or surface injection, when done outside the sealing of
the inside of the basement walls is. This method may in retrospect, ie for partial basements are carried out. In addition, in this case a sealing of the wall / floor union made with an injection.

basement waterproofing :

It will cellar interior surfaces without exposing the basement areas, ie without any excavation, inside sealed permanently. Even with running water, such seals be carried out. Over a given coating system, a pressure
made waterproof. In addition, after successful sealing a diffusible Restoration is applied.

Horizontal Waterproofing:

Rising damp in masonry will cause lasting serious damage. Signs are due to salt efflorescence flaking plaster, wallpaper and mouldering the formation of harmful mold. Based on a patented process will
eg by injection, has tabled a rot and permanently elastic synthetic resin into the masonry, so that a subsequent horizontal seal is given and no moisture can rise by capillary action.

crack injection:

component cracks are structural weaknesses. They shorten the life of the entire structure because the building is significantly weakened by water penetration. An elastic or non-positive crack closure is required.
This is filled by a pressure injection over the course of crack injection packer with a polyurethane resin. The applying injection resins are used in drinking water areas.